DUX COMPUTER DIGEST

 

Site Search

Site Info

Home » Forums » Forum Archives » Networking and Internet Sharing » Topic # 1159

Network Wall jacks (question)
qwikslvr Aug-29-01 09:51 AM
I am installing a home network. I Plan to use a Linksys BEFSR41 - EtherFast 4-Port Cable/DSL Router. Using cat5e cable. Can the wall modules at each termination point be female ??
Thanx,
Anthony

1. RE: Network Wall jacks (question)
lbyard Aug-29-01 03:22 PM
In response to message 0
The gender of RJ-45 wall jacks is female. Larry

2. RE: Network Wall jacks (question)
anthonymwright Sep-10-01 09:02 PM
In response to message 0
The key to fitting wall sockets as I have stated to Larry who is at present writing a whole chapter on this subject, is to disregard all colour codes on the socket, there is so many types and most with removable ID covers which are mostly put on the wrong way round.

You need to buy or borrow a LAN test kit usually around 60.00 in the UK, this may be a big outlay but you will forever be able to solve Network problems for yourself and others quickly as well as fitting wall sockets. I know this as I fit around 20 a week and every one was wired different.

1st: Print and keep hold off the 586A colour wiring codes from this fantastic sight.
2nd: At the Hub end make your own RJ45 plug corrctly and checkit,checkit,checkit, then put the Terminator end of your test kit on it.
3rd: cut the cable at the wall socket area with about 2 feet excess.
4th: Strip the cable back to 1 inch.
5th: Seperate and cut away the Brown and Blue pairs as they do nothing as Larry has stated, (he is right as well as God in my eyes).
6th: Put the remaining pairs into the socket and connect the tester to the outside.
7: Continue to remove and replace the 4 wires untill you have confimed with the tester which is wires 1,2,3,6.
8th: If your lucky then you will have 1,2,3,6, with Green lights and no Non-parity light (crossed T + R wires).
9th: Once you have 4 green light correctly showed then write down on paper, even draw a diagram of how that socket is wired, then pull them out and cut the cable back enough to fit the socket into the housing without squashing the wires.
10th: Before screwing down the wall plate chack again the socket from the outside.
11th: Once the socket is on the wall once again check it as you may have squashed a wire.


This is the only way to not waste time and to ensure you have a solid link to the Hub.

If you need more help then mail me through my web site. www.pcnetcomputers.com

All the best and good luck

Anthony (Martin) Wright


| Home | Guides | How to | Reviews | Online Store | FAQ | Forums | Forum Archives |
| Links | News | Newsletter | About Dux | Advertising | Contact Info | Privacy |